When processing mold, special materials or small tools machining, in order to improve the surface quality and machining
efficiency, the spindle speed may exceed 15000rpm, so you need to configure the electric spindle.
Typically, electric spindle use Ceramic ball bearing with the character of wear-resistance, corrosion-resistance, oil-free,
high temperature-resistance , long life-span and so on. In the high speed, spindle rotation produce heat because of
the friction between oil lubrication and bearing, which will lead to oil drying likely. Therefore, Oil air lubrication is required.
Electric spindle cooling device must be configured with the choice of water-cooled or oil-cooled. water-cooled is a better
way to cool, but you must add rust inhibitor in cooling water; oil-cooled effect is not as good as water-cooled, but no worried
about spindle rust problems.
653彩的新版网站Pay attention to the maximum spindle speed, it is attainable spindle speed which can not be used for a long time. The
actual processing speed is generally 80% of the maximum speed, depending on usage time.
653彩的新版网站If the customer needs for low-speed processing, usually not less than 10% of the maximum speed, otherwise actual cutting f
orce is low.If the customer still needs greater torque at low speed, we recommend the optional dual-coil motor spindle,
which can also apply to high and low speed processing, but the cost is more expensive.
Generally spindle taper is HSK or BBT standards at high speed which mainly because the spindle shank rigidity is better connecting
with the spindle, and less impaction by the centrifugal force.
Ceramic ball bearings have the following advantages compared with steel bearing:
1, high speed and acceleration-----dn value can operate under conditions of over 3 million, and the slip, abrasion and heat
653彩的新版网站can be reduced;
2, long life-span, wear-resistance----full ceramic ball bearing fatigue life expected 10-50 times longer than steel bearings,
hybrid ceramic ball bearing life than steel bearing life is about 3-5 times higher;
653彩的新版网站3, minimal lubrication ----- a low friction coefficient of the ceramic material, ceramic bearings lubricated by oil, even
653彩的新版网站less oil lubrication, its lubricating ability is still higher than the commonly used conventional steel bearing;
4, Abrasion-resistance and wear-resistance ---- because the ceramic material is inert material, Abrasion-resistance and
wear-resistance are better；
5, rigidity - the elastic modulus of the ceramic material is high, its rigidity is 15-20% larger than the ordinary steel bearing;
6, high temperature - Full ceramic ball bearings can operate in temperatures above 500 ℃;
653彩的新版网站7, torque low - according to the structure, torque on ceramic ball bearings reduce about one-third;
653彩的新版网站8, non-magnetic and non-conductive ---- ceramic ball bearings can not be damaged by magnetic and electrical